95 nitro 2000dc transom

Discussion in 'Nitro & Tracker Owners' started by RDenno, Nov 29, 2013.

  1. RDenno

    RDenno New Member

    Joined:
    Nov 29, 2013
    Messages:
    1
    Hi everyone I'm new to the site and I'm hoping that someone might be able to help me out. I own a 95 nitro 2000dc with a 93 johnson 200gt. Recently I had a pin in the ring groove let go and ruin my #2 cylinder. So the motor Is completely torn down now. But while it's off the boat I wanted to make sure that the motor is set at the correct height on the transom. I'm having a hard time figuring out if I measure to the very bottom of the boat where the live well and hull drain plug is which is around 27" or just straight down below the top of the transom to the top of the drains which would be 22". If someone could tell me which spot to measure to, the actual transom height, or correct shaft length it would help me out. Thanks for any help you can offer.
     
  2. Scott Hammer  TOXIC

    Scott Hammer TOXIC Active Member NTOWS Member

    Joined:
    Jul 16, 2002
    Messages:
    12,258
    Location:
    Warrenton, VA
    Google "prop to pad measurement" (or search here) for the correct way to determine you engine height. Normally 3 1/2 inches is optimum but every motor/prop combo can be different.
     
  3. Terry Rittenhouse

    Terry Rittenhouse Member NTOWS Member

    Joined:
    Jan 18, 2005
    Messages:
    53
    Sorry for the late reply. Try this site, www.stevescustomprops.com. In the FAQ section there is a disgram showing how to measue for this. Hope it helps you.
     

Share This Page